A factory and a workshop differ in scale, not in kind. Both spend electricity on production, both keep hours the sun mostly agrees with, and both punish systems that were sized from roof area instead of from the load curve. This guide gives the shared method.
Begin with the production calendar and the electricity records that describe it. Mark the loads that define the building: the largest motors, the processes that cannot pause, the shifts that run into darkness. A workshop's list is shorter than a factory's, but the questions are identical, including the uncomfortable one — what should happen to production when the grid fails at the busiest hour?
The storage decision follows from that answer. Protecting a whole production line through an outage is a major configuration; protecting controls, lighting and one essential process is a different, cheaper one. Both are legitimate. What is not legitimate is leaving the question unasked and discovering the system's answer during the first real failure.
The 200KW factory configuration shows the completeness to ask for: array composition, inverter, storage options and structural figures in one document. Your workshop's configuration will be smaller in every figure and should be identical in completeness.
Before ordering, confirm the minimum order quantity and lead time for your configuration, and ask which documents apply to the exact system you are quoted.
Send an inquiry